Folder Speed; Display Contrast; Quantity And Batch Mode; Quantity - Martin Yale 2051 Installation Operation & Maintenance

Martin Yale 2051 Folder
®
3.4

Folder Speed

To adjust the speed of your folder, press the "SPEED" button, and then press either the
increase or decrease button (as described in section 3.1 - Incremental Adjustment
Buttons). Folder speed can be adjusted while the folder is running. For most all folding
jobs, the folder can be run at full speed (100%).
3.5

Display Contrast

To adjust the display contrast of the LCD display, press the Display Contrast button, and
then press either the increase or decrease button (as described in section 3.1 -
Incremental Adjustment Buttons).
3.6

Quantity and Batch Mode

The Quantity (#) is used to specify the total number of sheets to be folded, and to specify
a Batch quantity.

3.6.1 Quantity

To program a specific number of pages to be folded, press the Quantity (#) button once.
Pressing the Quantity (#) button twice will skip the Quantity screen and place you directly into Batch
Mode.
Using the numbers on the keypad, enter the quantity of sheets to fold, and press the enter key. After
entering a quantity, you will automatically enter Batch Mode.

3.6.2 Batch Mode

The Batch Mode function gives you the ability to fold and deliver a specified number of sheets as a
"batch", and automatically places a gap between batches to allow easy retrieval of the batch to
packaging. This run/pause/run sequence will continue until the Stop button is depressed, the Feed
Table becomes empty of paper, a folding error is encountered, or the programmed quantity reaches
zero.
To enable Batch Mode, enter a Batch quantity value greater than zero. This quantity is the number of
sheets that will be folded and delivered as a "batch". When the entered quantity of sheets has been
folded, the folder will suspend feeding until the Exit Conveyor has become clear of paper, then folding
will resume. To disable Batch Mode, enter a Batch quantity of zero.

3.6.3 Stacking Problems

Occasionally, you may find that the folded paper is not stacking cleanly because of a particular type of
fold or paper weight. A condition such as this can result in a paper jam because paper piles up
between the Stack Wheels and the fold rollers, allowing paper to be drawn back into the spinning
rollers.
To eliminate the possibility of this occurring, as an extension of the Batch Mode, folded sheets can be
delivered one at a time with a slight delay between pages to insure that the folded sheets have become
captured by the Stack Wheels.
Setting the Batch quantity to "1" instructs the folder to feed one sheet at a time, and to wait for the Exit
Conveyor sensor to become clear, before feeding the next sheet. This insures that the Stack Wheels
have a firm grasp of the previously folded sheet before the next sheet is fed into the folder.
Revision 3.0
ENTER QUANTITY TO GO
Qty To Go=
Martin Yale Industries, Wabash, Indiana, USA 260-563-0641
0
Figure 18
(2051.09.03.16.11.40)
Page 13 of 52