Chapter 6 Using the ColorCut SC5000 Cutter (Cont.)
6.2.1 Start Up Screen
When you power on the Intec SC5000 cutter, the following message should be
displayed on the LCD panel
moving until you press the [ENTER] (hard) key
⑩
Off/Line
IF you have powered on the SC5000 cutter using the POWER switch at the back
of the machine (See section 4.1) and the Power switch is Illuminated, but you do
not see anything on the display, and the RED LED is not Illuminated. Then it is
likely the EMS switch (Emergency Stop Switch) (see section 1.3 item 9 ) has been
depressed/activated. To release the EMS function - press and slightly twist the
EMS button so it goes back UP. Now Power will reach the display and the red
LED
6.2.3 The HOME screen
When the normal 'HOME' screen is displayed, the Speed and Force for the each tool
on the tool carriage is displayed and can be adjusted. In addition the FUNCTION TAB
bar across the base of the display is available.
Off/Line
Intec Printing Solutions - Manual for ColorCut SC5000 Auto-Sheet Digital Die-Cutter ............................................................ Page No: 40
②
. This is a safety warning, that prevents the carriage
ENTER
⑧
K
will be illuminated and the display will be as shown above.
ENTER
⑧
on the control panel.
TOOL 1
TOOL 1
SC5000
TOOL 1
960
350
mm/s
SPEED
TOOL 2
960
750
mm/s
SPEED
②
OFF-LINE
g
FORCE
g
FORCE