Table of Contents
Advertisement
4.2 Connecting to your computer
The Intec ColorCut Pro software includes the USB drivers built into the software. There
is no need to install any addition drivers.
Please note, that operation can not be guaranteed in the following
circumstances:
1) When connection is made through a USB hub or an add-on USB board.
2) When you are using a custom-built computer that has been modifi ed.
For optimal results, please ensure the following:
•
Do not connect or disconnect the USB cable
while you are installing the Intec ColorPro
software.
•
Do not connect or disconnect the USB cable
while starting up the computer.
•
Do not connect or disconnect the USB cable
while switching on the cutter.
•
Do not disconnect the USB cable within a 5
second period of connecting it. (It does not
always recognise the fact it was subsequently
disconnected and won't reconnect again until you
power-cycle both devices)
•
Do not disconnect or connect the USB cable while you are cutting a job,
or while data is being transferred.
Securely plug the USB cable into the USB socket
your Windows PC.
4.3 ColorCut Pro - USB Connection
confi rmation
Launch ColorCut Pro, to check the cutter can be
seen correctly.
To launch ColorCut Pro, use the method as
described in section 3.4 (also detailed following)
Use the Windows [START] menu, (or press
the Windows key)
[ColorCut Pro] icon from the Intec folder B.
Alternatively, type the fi rst few letters of
ColorCut Pro in the search bar C, to fi nd
the ColorCut Pro application.
You can PIN the ColorCut Pro application to
the START bar, or quick launch taskbar
required.
Intec Printing Solutions - Manual for ColorCut SC5000 Auto-Sheet Digital Die-Cutter ............................................................ Page No: 31
and select the
D
if
B
B
on the rear panel and connect to
B
C
D
Advertisement
Table of Contents
