Installation Of The Sc5000 Cutter (Overview Of Steps) - Intec ColorCut SC5000 Series Installation Manual

Installation of the SC5000 Cutter (Overview of steps)

1
2
3
4
5
6
7
Intec Printing Solutions - Manual for ColorCut SC5000 Auto-Sheet Digital Die-Cutter .............................................................. Page No: 9
INSTALLATION
START
Unpacking & positioning the SC5000
Unpack the Intec SC5000 cutter, check the accessories.
features of the SC5000. Then position the cutter with enough room to load media
and for the retractable exit tray to be opened.
Setup Wi-Fi HotSpot
Confi gure the Wi-Fi Hotspot to receive the Live video feed
(Install provided Wi-Fi dongle if your PC doesn't have Wi-fi capabilities
Install the Software
Install the supplied ColorCut Pro software for Illustrator or CorelDRAW.
(Install Mac client where applicable)
Connect to your Computer
Using the supplied USB cable connect the cutter to your PC. Then
check in the software that the cutter can be seen.
The ColorCut SC5000 Tools
Overview of the Blade Holder, different blade types and creasing tool.
Setting the blade depth. How to install the Blade, Creasing & Pen Tools.
Use the cutters' LCD panel to calibrate Tool2 to Tool1.
LCD Panel & Calibrating the Cutter
Turn cutter on, check Cutter appears on Wi-Fi Hot-Spot, launch ColorCut Pro.
Calibrate the offset of the Vison3 CCD sensor to the Tool1 cutting position in
your software.
Load media and perform test cut
Use TEST cut to perform a cutting test and adjust blade if necessary.
Load your media and start cutting.
(Please refer to your ColorCut Pro, Cut fi le design & Daily Operating Manual.
INSTALLATION
FINISHED
Get familiar with the key