Table of Contents
Advertisement
5.2 The Blade Holder - an introduction
When handling
cutter blades, be
careful to avoid
cutting your fi ngers or
other parts of your body.
5.3 Replacing the blade
The blade is a consumable item and
you'll always get the best quality cut with
a newer blade. Please replace with a
new blade when the cut quality reduces.
For Standard blades
(Without the circlip)
1. Push the blade into the
bottom of the blade holder.
2. Adjust the amount of
exposed (visible) blade
tip to a suitable length by
C
rotating
the "Adjustment
depth knob" and then tighten
D
the lock
.
3. Press the push-pin
remove the blade from the
blade holder when replacing
blade
Intec Printing Solutions - Manual for ColorCut SC5000 Auto-Sheet Digital Die-Cutter ............................................................ Page No: 35
C
D
B
B
to
B
Pin
C
Blade Depth Adjustment
D
Lock
E
Flange
F
Exposed Blade
For CirClip Blades
1. Unscrew the lower (cover)
part of the blade holder.
2. Insert the Circlip blade into
the inner blade holder.
replace the outer cover of the
blade holder;
3. Adjust the amount
of exposed (visible) blade tip
C
to a suitable length by rotating
D
C
the "Adjustment depth
knob" and then tighten the
D
lock
4. Replace the blade by following the
steps above (Note: You cannot push the
pin as you do with standard blades as the
circlip prevents the blade being removed.
Then
.
Advertisement
Table of Contents
