Table of Contents
Advertisement
5.5.1 Installing Tools in your ColorCut (cont.)
2.
Push the tool, i.e. the Blade
Holder or Calibration Pen all the
way into the tool holder position 1
until the tools' fl ange completely
touches the upper part of the
holder.
Push the creasing tool all the
way into tool position 2, until the
creasing tool fl ange complete
touches the upper part of the tool
holder.
3.
Make sure that the tool bracket is engaged on top of the tool's fl ange
tighten the screw.
It is IMPORTANT, the BRACKET to hold the Tool, is OVER the Flange as this will
hold the tool down. (If the Flange is above the bracket that holds the tool
tool height will be incorrect AND the tool may gradually move up during operation).
After fi tting the Blade Tool in position 1, repeat the same process for the Creasing
Tool in Position 2.
Intec Printing Solutions - Manual for ColorCut SC5000 Auto-Sheet Digital Die-Cutter ............................................................ Page No: 38
Bracket to
hold tool
Flange
Tool holder
F
E
YES
E
, and then
N O
F
, the
Advertisement
Table of Contents
