Table of Contents
Advertisement
Steps
1. Remove the two (M2x3) screws that secure the left display hinge to the system.
2. Lift the left hinge in upward direction away from the system.
3. Open the latch and disconnect the Input Output board cable from the connector on the Input Output board.
4. Remove the (M2x2.5) screw that secures the Input Output board to the palmrest assembly.
5. Lift the Input Output board off the palmrest assembly.
Installing the Input Output board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the I/O board and provides a visual representation of the installation procedure.
Removing and installing components
43
Advertisement
Table of Contents
