Table of Contents
Advertisement
3. Install the microSD-card.
4. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the microSD-card.
3. Enter the
service
mode.
4. Remove the
base
cover.
About this task
NOTE:
When the coin-cell battery is removed, it clears the CMOS settings.
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
Steps
1. Disconnect the coin-cell battery cable from the connector on the system board.
2. Lift and remove the coin-cell battery from the palmrest assembly.
Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
26
Removing and installing components
After working inside your
before working inside your
computer.
computer.
Advertisement
Table of Contents
