Table of Contents
Advertisement
Steps
1. For visibility, open the solid-state drive mylar sheet that covers the solid-state drive.
2. Disconnect the system fan cable from the connector on the system board.
3. Remove the two (M2x3) screws that secure the system fan in place.
4. Lift the system fan off the palmrest assembly.
Installing the right system fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the right system fan and provides a visual representation of the installation
procedure.
36
Removing and installing components
Advertisement
Table of Contents
