Table of Contents
Advertisement
Steps
1. Align the notch on the solid-state drive with the tab on the M.2 card connector.
2. Slide the solid-state drive into the M.2 card connector on the system board.
3. Align and place the solid-state drive bracket.
4. Install the screw (M2x3) that secures the solid-state drive bracket to the system board.
5. Close the solid-state drive mylar sheet to cover the solid-state drive.
NOTE:
There is a protective mylar sheet covering the solid-state drive. This mylar sheet must be closed after the
installation procedure.
Next steps
1. Install the
base
cover.
2. Exit the
service
mode.
3. Install the microSD-card.
4. Follow the procedure in
After working inside your
computer.
Removing and installing components
19
Advertisement
Table of Contents
