Installing The Input Output Board; Power Button; Removing The Power Button - Dell Vostro 5471 Owner's Manual

Installing the Input output board

1. Place the Input output(I/O) board to its slot in the system.
2. Replace the two M2.0 x 4 screws to secure the I/O board to the system board.
3. Connect the I/O cable and the fingerprint cable and close the latch to secure it to the I/O board.
4. Install the:
a. WLAN
b. solid state drive(SSD)
c. base cover
5. Follow the procedure in

Power button

Removing the power button

1. Follow the procedure in
2. Remove the: .
a. base cover
b. WLAN card
c. Input output(I/O) board
3. To remove the power button:
a. Remove the two M2.5 x 6 screws securing the right display hinge to the system [1].
24 Removing and installing components
After working inside your
Before working inside your
computer.
computer.