Table of Contents
Advertisement
Steps
1. Open the solid-state drive mylar sheet that covers the solid-state drive.
NOTE:
There is a protective mylar sheet covering the solid-state drive. This mylar sheet must be opened in order to
proceed with the removal procedure.
2. Remove the screw (M2x3) that secures the solid-state drive bracket to the system board.
3. Remove the solid-state drive bracket from the system board.
4. Slide and remove the solid-state drive from the M.2 card connector on the system board.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
18
Removing and installing components
Advertisement
Table of Contents
