Table of Contents
Advertisement
Steps
1. Align and place the Input Output board on the palmrest assembly.
2. Install the (M2x2.5) screw to secure the Input Output board to the palmrest assembly.
3. Connect the Input Output board cable to the connector on the Input Output board and close its latch.
4. Gently press the left hinge in downward direction toward the system.
5. Install the two (M2x3) screws to secure the left display hinge to the system.
Next steps
1. Install the
base
cover.
2. Exit the
service
mode.
3. Install the microSD-card.
4. Follow the procedure in
Heatsink assembly
Removing the heatsink assembly
Prerequisites
1. Follow the procedure in
2. Remove the microSD-card.
3. Enter the
service
mode.
4. Remove the
base
cover.
44
Removing and installing components
after working inside your
before working inside your
computer.
computer.
Advertisement
Table of Contents
