Audio Routing Settings - Bosch DICENTIS Configuration Manual

DICENTIS
–
–
–
–
Refer to
–
–
5.4.6

Audio routing settings

The following options are available for the audio routing:
–
Bosch Security Systems B.V.
– In 2 Sets the sensitivity of Line/Dante
– Out 2: Sets the sensitivity of Line output 2.
– In 2 / Out 2 mode selection menu: Defines the mode of Line/Dante
TM
and Line/Dante /OMNEO output 2. Click the arrow on the drop-down list to choose
between:
LSP: When selected, allows the audio from the delegate's loudspeaker to be
amplified by an external system.
Recorder (Int. floor): When selected, allows the audio to be recorded or sent to
interpreters.
Mix - Minus: When selected, prevents acoustic feedback when two systems are
connected for example via telephone coupler.
Insertion: When selected, allows an external system to process/equalize the audio.
Unprocessed: When selected, receives / sends the unprocessed audio (also referred
to as dry signal) from In 2 / Out 2.
Acoustic Feedback:
– No Acoustic Feedback Suppression (AFS): Off, sets the AFS function to "off".
– Natural speech Acoustic Feedback Suppression: Sets the AFS function to "on" and
selects the natural algorithm for speech.
– Maximum Acoustic Feedback Suppression: Sets the AFS function to "on" and
selects the maximum algorithm for speech, which reduces the risk of acoustic
feedback (howling) at higher system volume levels.
Note: Audio artifacts might occur at higher volume levels.
– Loudspeaker is active when microphone is on: Enables the loudspeaker of the
device, when the microphone is on.
– Attenuate headphone when speaking by x dB: x can be set using the textbox or the
slider. The range of x is 0 dB up to 12 dB. Attenuates the headphone volume of the
device, when the microphone is on.
Mute: When selected, mutes the Line Input / Output or Dante Input / Output. There are
separate mute buttons for In 1 / Out 1 and In 2 / Out 2.
Test Tone: To test the audio in the system. Select either Off, 1 KHz, or Sweep.
Note: When a Test Tone option is selected the Test Tone checkbox appears in the
System and Line Input / Output fields.
Headroom: When Unprocessed is selected, the headroom can be set for the Line 2 and
Dante 2 outputs. The range is from 3 dB up to 30 dB. Headroom is the buffer you have
against transient peaks or loud sounds before the system goes into clipping.
Configuring Dante™ compatible devices, page 121
Audio routing settings, page 67
LSP: Use this mode if you want audio output 2 of the Audio processor and powering
switch to transmit a signal that can be connected to an external public address system.
The Audio processor and powering switch sets:
– volume signal level.
– audio equalization.
Audio input 2 signal of the Audio processor and powering switch is added to the floor
signal.
TM
/OMNEO input 2.
Configuration manual
Meeting application | en 67
TM
/OMNEO input 2
2021.06 | V3.7 |