Configuring An Idesk (Directly On The Device) - Bosch DICENTIS Configuration Manual

DICENTIS
8

Configuring an IDESK (directly on the device)

To configure the DCNM-IDESK / DCNM-IDESKVID on the device itself, press the B - B buttons
at the same time. The B - B buttons (input channel B and output channel B) are located on
both sides of the display and can be easily recognized by the small raised dashes. The
configuration pane opens with these options:
–
–
–
–
–
–
–
Refer to
–
Bosch Security Systems B.V.
Booth No. - Desk No.: To assign a device to a booth and a desk within that booth. If you
assign a desk to a number that has already been used, the previous booth - desk
combination will be overwritten by the new desk.
Note: When you connect a new desk to a DICENTIS system, it will not be assigned
automatically, but you have to configure it via the B - B buttons on the desk or via the
Meeting application/API. When a desk is connected that was connected before, it will
return to its original booth and desk number.
Available languages: Offers you the possibility to configure the number of languages and
which languages are available. Use Language selection, page 75 to determine which
languages are available.
Output A + B + C: Select the language for the A output (usually the language the
interpreter interprets to) and the languages for the B and C outputs (from the list of
available languages).
Display brightness: Adjust the brightness of the display by pressing the button (1 - 15)
and using the rotary control. The default value is 7.
Auto configure desks: Automatically configures all interpreter desks in the system. This
means the A output will be set to the language that corresponds to the booth number.
The B and C outputs will be set to none and the 7 pre-select buttons for the input
languages will be configured as 1
on.
System information: Shows system information for the interpreter device and OMNEO
(firmware version, IP address, etc.).
Click the Exit button (at the lower right side from your display) to exit each of the above
menu options.
Note: All changes made in the configuration on the Interpreter desk are directly visible in
the Meeting application (real-time) and may impact the meeting (if there is an active
meeting going on). Therefore, when there is an active meeting, no changes in the
configuration should be made.
Note: For instructions on how to operate the interpreter desk (for interpreters), please
refer to the Quick reference card that is provided separately for the DCNM-IDESK /
DCNM-IDESKVID.
Language selection, page 75
Configuring an IDESK (directly on the device) | en
st st
button - 1 language, 2
Configuration manual
nd nd
button - 2 language, and so
2021.06 | V3.7 |
97