Bosch DICENTIS Configuration Manual page 17

DICENTIS
5.
6.
7.
8.
9.
10. Multimedia device (DCNM-MMD / DCNM-MMD2)
11. Interpreter Desk (DCNM-IDESK / DCNM-IDESKVID)
Participants can use their DICENTIS Discussion device to contribute to a meeting: DCNM-D,
DCNM-DVT, DCNM-DSL, DCNM-DE.
A typical camera setup in a DICENTIS Conference System consists of:
Figure 3.2: Typical camera setup
Bosch Security Systems B.V.
– Ethernet switch with PoE on some ports.
- Routes the system data via Ethernet.
- Provides power to the DICENTIS devices via PoE.
CAT‑5e Ethernet cable (minimum requirement).
Powering switch (DCNM-PS2):
– Is used to increase the number of DICENTIS devices connected to the system.
Audio processor and powering switch (DCNM-APS2):
– Controls the system audio, routes audio from and to the system and supplies power
to the DICENTIS devices.
System Network Cable (DCNM‑CBxxx):
– Connects DICENTIS devices, the Audio processor and powering switch, and one or
more Powering switches to each other.
Multimedia device (DCNM-MMD / DCNM-MMD2)
– This device is used for "system power on/off". It is always connected to the powered
socket of the Audio processor and powering switch or Powering switch.
Note: Only one DICENTIS Multimedia device should be connected here.
– This device is used via a "Power over Ethernet" (PoE) Ethernet switch.
Note: Only one DICENTIS device should be connected here.
– Provides extensive facilities for professional interpretation for the DICENTIS
Conference System.
Note: A maximum of 10 desks can be installed per booth.
Configuration manual
System overview | en 17
2021.06 | V3.7 |