Assa Abloy Corbin Russwin Access 700 ED5000N Series Installation Instructions Manual page 8

ED5000N Series Exit Devices For
9700 TCPIP1 & PWI1 Series Trim
5. Install Head Cover:
a. Lay device wire harnesses across ¾" hole (Fig. 5a).
b. Tuck wires into hole when installing cover so that wires are not pinched between head cover
and door.
c. Attach head cover using (2) #8-32 flat head screws (Fig.56b).
Fig. 5a
Important Note: Rim Exit Installation Continues on Page 13 - Section 7
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Rim Exit Installation Instructions (Continued)
Use 3/4" hole to
tuck trim and
device wire
harness under
head cover
8
Fig. 5b