Assa Abloy Corbin Russwin Access 700 ED5000N Series Installation Instructions Manual page 10

ED5000N Series Exit Devices For
9700 TCPIP1 & PWI1 Series Trim
6) Mortise Exit Installation Instructions (Continued)
3. Install Mortise and Outside Trim Assembly:
a. Make sure tailpiece is oriented vertically.
b. Feed trim wire harness through wire harness hole (Fig. 3a).
c. Mount trim assembly to door pulling slack wire towards device side of door.
Note: Be careful not to pinch wire harness.
d. When mounting trim, lift tailpiece to pass through hole on device side (Fig. 3b).
Note: Ensure tailpiece is still oriented vertically.
e. Fasten trim assembly to door using (2) 1/4-20 oval head screws and (2) finish washers (Fig. 3b).
Note: Finger tighten only.
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
Fig. 3a
10
Fig. 3b