Assa Abloy Corbin Russwin Access 700 ED5000N Series Installation Instructions Manual page 23

ED5000N Series Exit Devices For
9700 TCPIP1 & PWI1 Series Trim
2. Installation of Connectors
CAUTION - Do not touch or allow debris to enter connector contacts.
Secure the following connectors to their respective terminals (Fig. 13A, B):
A. Secure the 4-pin DPS connector.
B. Secure the 10-pin lock body assembly connector.
*NOTE: Optional 2-pin external 9-24VDC power connector (PWI1- Wireless only).
Board-to-Board
Connector
Wire Positioning:
Please follow these steps prior to installing
inside escutcheon to prevent any damage
caused by pinching wires:
C. Tuck excess cable into wire hole on inside of door.
D. Finish securing mounting plate and reader to door by fully
tightening through-bolts on inside of door.
E. Secure the 24-pin card reader connector.
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
9) PWI (Wireless) Wiring & Installation (Continued)
Reader
DPS
(24-pin)
(4-pin)
Fig. 13a
9-24VDC
Power*
Lock
Body
(10-pin)
23
Mounting Plate
A
E
Fig. 13b
Lock body
B
cable