Assa Abloy Corbin Russwin Access 700 ED5000N Series Installation Instructions Manual page 24

ED5000N Series Exit Devices For
9700 TCPIP1 & PWI1 Series Trim
3. Install Inside Module Component Assembly
a. Insert top tabs of controller into slots on mounting plate (Fig. 14).
b. Ensure proper alignment of board-to-board connectors while pivoting bottom
of controller toward door until tab on bottom snaps securely into place on
mounting plate.
CAUTION: To avoid possible damage to board-to-board connectors,
care should be taken when securing controller to mounting
plate. If there is resistance when securing, detach controller
to determine cause before re-attaching controller.
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
9) PWI (Wireless) Wiring & Installation (Continued)
Fig. 14
24