Assa Abloy Corbin Russwin Access 700 ED5000N Series Installation Instructions Manual page 12

ED5000N Series Exit Devices For
9700 TCPIP1 & PWI1 Series Trim
6) Mortise Exit Installation Instructions (Continued)
5. Install Head Cover:
a. Lay device wire harnesses across ¾" hole (Fig. 5a).
b. Tuck wires into hole when installing cover so that wires are not pinched
between head cover and door.
c. Attach head cover using (2) #8-32 flat head screws (Fig. 5b).
Fig. 5a
Important Note: Mortise Exit Installation Continues on Page 13 - Section 7
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
Use 3/4" hole to
tuck trim and
device wire
harness under
head cover
12
Fig. 5b