Assa Abloy 7003 User Manual

User Manual
7003 Smart Door Lock
Product Layout:
Inside Handle
Please keep internal/external panel clean before installation.
Handle change direction Lock body change direction
Latch adjust parts Commutate
latch
lock body
liner
Pull spindle out and turn 180 degree
2
Front rose back rose
Outside Handle
Function button
Rose
Panel and lock body installation steps.
1. Adjust latch direction according to door opening side.
2. Lock body: Put lock body into hole made then tighten screw.
3. Put M 5 stud on front rose and use screwdriver tight it, data line and spindle go
1.When installing lock
thought lock body together properly and data line go thought back handle, then tight
sure batch bolt should
M4*35 screws on back rose, last test lock body latch and bolt should work well.
always on top and dead
bolt at. 4.Connect front data line onto port at back handle and put 4*AAA battery into handle,
2.Please adjust latch bolt after heard: "Du" means connected, last put battery cover on handle properly.
slope when necessary.
5. Put M 5 stud on front rose for cylinder then hole made for it and back rose should be
a.Latch bolt commutator
connect with right position then tight M4*35 screws. Cylinder go thought rose and
follow arrow direction that
screw in cylinder screw on liner.
push latch bolt in adjust it
as required.
6.Install buckle plate and buckle box on frame, make sure bolt and latch work smoothly.
b.Turn latch bolt 180° and
7. Try handle & lock body see if work smoothly otherwise check again until work well.
take it out from liner after
adjusting.
Change battery by using A screwdriver from back handle
.
3