Removing / Inserting The Sd Card - Safety Vision OBSERVER 4816-NVR Hardware User's Manual

9

Removing / Inserting the SD Card

The SD card access door is secured by the hard drive canister and can only be opened when the hard drive canister is removed.
WARNING: Do not remove the SD card until the NVR is turned off.
WARNING: Do not force the SD card into the slot upside down or backwards.
To remove the SD card from the NVR
1. Remove the hard drive canister using the procedures described in "To remove the hard drive from the NVR" (pg. 7).
2. Open the SD card slot door from the top edge.
3. Lightly push on the SD card until a "click" is felt, then allow it to spring out of the slot. The SD card partly ejects.
4. Pull the SD card straight out.
To reinsert the SD card into the NVR
NOTE: Ensure the SD card's write protection slider is in the "unlocked" position.
NOTE: Use only SD cards obtained from Safety Vision.
1. Insert an SD card into the SD card slot label-side up, with the notch to the right, until it clicks in place.
2. Replace the hard drive canister using the procedures detailed in "To reinsert the hard drive into the NVR" (pg. 7).
OBSERVER ™ 4816 HVR HARDWARE USER GUIDE