Removing / Inserting The Sd Card - Safety Vision SVR-4401-3C User Manual

Removing / Inserting the SD Card

WARNING: Do not remove the SD card until the NVR is turned off.
WARNING: Do not force the SD card into the slot upside down or backwards.
To remove the SD card from the NVR
1. Insert the key into the faceplate lock and turn it counter-clockwise.
2. Open the SD card slot door from the right edge.
3. Lightly push on the SD card until a "click" is felt, then allow it to spring out of the slot. The SD card partly ejects.
4. Pull the SD card straight out.
To reinsert the SD card into the NVR
NOTE: Ensure the SD card's write protection slider is in the "unlocked" position.
NOTE: Use only SD cards obtained from Safety Vision.
1.
Insert an SD card into the SD card slot label-side up, with the notch to the right, until it clicks in place.
2. Close and lock the SD card slot door.
OBSERVER 4401-HVR HARDWARE USER GUIDE 8