Options For Ventillation - ElectrIQ eiQCURV60SC Installation And User Manual

OPTIONS FOR VENTILATION
This hood can be set up for either external venting or recirculation of the
air. The type of setup should be decided before commencing installation.
EXTERNAL VENTING
If you have an outlet to the outside, your
cooker hood can be connected as shown
in the diagram using the flexible exhaust
pipe (supplied). Alternatively any suitable
extraction duct (enamel, aluminium,
flexible pipe or inflammable material with
an interior diameter of 150mm) can be
used.
An adaptor is also supplied to enable you
to connect your hood to pre existing
120mm diameter ducting.
If this is the chosen installation method consideration to the route of the
vent pipe should be made prior to installation.
Please note: the performance of the hood may be affected if the diameter
of the pipe is reduced, or if the airflow is restricted.
RECIRCULATION
This cooker hood also supports the recirculation
of air once it has passed through the filters.
The filtered air is then expelled through the vent
holes in the side of the chimney.
When setting the unit up in this configuration,
carbon filters should also be used to remove
odours from the air. Details of sourcing and
fitting the filters can be found in the carbon filter
section of this manual.
When setting up for recirculation the installation instructions should be
followed, but the vent pipe should not be attached, allowing the air to be
expelled through the vents on the side of the chimney.
7