ElectrIQ eiQCURV60SC Installation And User Manual page 10

7. Hang the hood on the
Installation plate, and
secure to the wall
using two screws
(ST5*50) through the
lower chimney
bracket into the wall
plugs previously
inserted.
8. If the hood it to be vented externally, push the exhaust pipe onto the
top of the hood, and route it externally.
9. Slide the inner chimney up to the correct
height and fix into position on the upper
chimney bracket using the remaining two
screws (ST4.2*9.5).
5. Slide the chimney sections onto
the hood. Fix the base of the
lower chimney section to the
hood using two ST4.2 x 9.5mm
screws (supplied)
6. Fix the lower chimney bracket
to the top of the lower chimney
using two ST4.2 x 9.5 screws
(supplied).
10