Wiring Instructions - Mile Marker PE2500 Installation & Operator's Manual

NOTE: Be sure to mount control box in a location that: does not interfere with any vehicle's moving/functioning parts, and use
electrical cables with similar specifications as that provided by Mile Marker if a substitution is required.
CAUTION: Battery cables should not be drawn taut, leave some slack for cable movement. Ensure that they are routed properly with out
any interference with the vehicular components that could potentially damage the cable or cause electrical short.
Long battery cable runs may have significant voltage drops that may cause the winch motor controller to not operate
properly.
DO NOT CONNECT POWER CABLES TO BATTERY
UNTIL FINAL STEP OF INSTALLATION
Solenoid "A" terminal
to motor (-)
(Black cable)
A
To negative (-)
battery terminal
(Black cable)
-
Fig. 2-1
PAGE 5

WIRING INSTRUCTIONS

To positive (+)
battery terminal
+
(Red cable)
B
Solenoid "B"
terminal to
motor (+)
(Red cable)
To winch control
socket
2121 Blount Road Pompano Beach, FL 33069
From solenoid
terminal "B" (+)
(Red cable)
B
A
From solenoid
terminal "A" (-)
(Black cable)
Winch control socket
MileMarker.com 1.800.886.8647