Winch Operation - Mile Marker PE2500 Installation & Operator's Manual

Function Testing
After checking all connections in accordance to installation instructions prior, connect power cables to vehicle's battery. Attach black cable to
negative (-) battery terminal and secure, followed by attaching the red cable to positive (+) battery terminal.
1. Before testing the winch, turn the clutch handle to the "Freespool" position. Always wear heavy gloves when handling steel cable/synthetic
rope. Using the winch strap, pull about two feet of steel cable/synthetic rope off the drum, and place the clutch handle in the "Engaged" posi-
tion (Fig. 3-1).
2. Toggle the joystick "down" to retrieve line. When using the handlebar remote, you can also toggle the "IN" button for the same retrieval function
(Fig. 3-2). The steel cable/synthetic rope will spool in on drum.
NOTE: If steel cable/synthetic rope is spooled "OUT" while pressing the "IN" function, please refer to Fig. 2-1 on page 5, and switch power cables
to opposite studs on motor.
3. Toggle the joystick "up" to power OUT steel cable/synthetic rope. When using the handlebar remote, you can also toggle the "OUT"
button for the same power out function (Fig. 3-2). The steel cable/synthetic rope will spool out off of drum.
4. If any of the above functions are not working properly, recheck all connections in accordance with wiring instructions in this manual, or
refer to troubleshooting section in the back of manual.
2121 Blount Road Pompano Beach, FL 33069

WINCH OPERATION

Engaged
Make sure
winch lever is
fully engaged
MileMarker.com
Freespool
Fig. 3-1
Fig.3-2
1.800.886.8647 PAGE 6