Wiring Instructions - Mile Marker H Series Installation And Operator's Manual

Electrical Connections
The Mile Marker valving system is designed to default to the power steering gearbox so power steering is always available even when the winch
is in use. The power source to the solenoid is not energized until the four pole Quick Connector Plug is plugged in. Each solenoid has two black
wires, either of which can be used as a ground or for electric power. The grounds are connected to each other at the factory. The other black
wires plug to the white and black wire in the harness (see illustration). Determine a location on the front grill to mount the female 4-pole plug
connector. If desired, the female 4-pole plug connector is connected to the winch with the top motor bolt. If you choose to take the plug out of
the box, drill four holes at your desired location and secure with screws. Attach the circuit breaker to the vehicle under the hood. Connect all
wiring as shown in illustration. Test hand control unit. Solenoids will make a slight "click" sound if connected properly.
DO NOT CONNECT POWER CABLES TO BATTERY UNTIL FINAL STEP OF INSTALLATION!
Figure 2
Disc must be installed in the port that goes to the top port on motor. Disc must be installed with cut side to motor.

WIRING INSTRUCTIONS

Page 8