Table of Contents
Advertisement
WIRING INSTRUCTIONS
Electrical Connections
The power source to the solenoid can not be energized until the four pole quick connector plug is plugged in. Each solenoid has two black
wires that are connected to each other at the factory and are grounded. The other black wires will plug into the white and black wires from
the hand control connection (Fig. 2). The brown wire will go to ground from the female 4 pole plug gray box. Attach the circuit breaker to the
vehicle under the hood. Connect all wiring as shown in illustration. Test hand control unit, solenoid will make a slight "click" sound if
connected correctly. Do not start vehicle to do this test.
DO NOT CONNECT POWER CABLES TO BATTERY UNTIL FINAL STEP OF INSTALLATION!
- Ground
12V
+Green
Female
Female
4 Pole plug
quick connector
Cable
Circuit breaker
Valve
- Ground
Fig. 2
When done, check fluid level. Replace lost fluid in system until full. To purge air, start engine, run for two seconds and shut off engine. Check
fluid level again. Add fluid until full. Do this until system stays full. Run vehicle for three minutes or until fluid looses aeration. After system
has been filled, turn wheels from lock to lock position (completely right and left) five times. This will aid in bleeding out any air that may still
be in the system. If the hand control unit is working backwards, simply reverse the connections at the solenoids (switch the white and black
wire on the solenoid valve (Fig. 2). Make sure that you hear a slight "hiss" when the hand controller is pressed "out" when the vehicle is
running.
CAUTION:
Winch cable must be wound onto the drum under a load of at least 500 lbs or outer wraps will draw into the inner wraps and
damage the winch cable
PAGE 6
2121 Blount Road Pompano Beach, FL 33069
MileMarker.com
1.800.886.8647
Advertisement
Table of Contents
