Wiring Instructions; Wiring The Control Box - Mile Marker SEC15 Installation & Operator's Manual

Wiring the Control Box

1. Slip the boots onto pertinent cables and make electrical connection in accordance with the schematic on following page. Slide the boots
onto all the electrical connections made (Fig. 2-12 through 2-14).
2. Run battery power cables carefully under hood of vehicle, avoiding interference with moving parts and abrasion points which could
potentially cause electrical short.
3. Attach BLACK Cable to NEGATIVE Battery Terminal (-), followed by RED Cable to POSITIVE Battery Terminal (+) (Fig. 2-14). Refer to Winch
Operation on page 8 of this manual for proper functioning; if drum rotates in the incorrect direction when "IN" button is pressed, green and
yellow motor cables need to be switched.
CAUTION: Cover all exposed electrical connections with insulation boots to avoid electrical short. Battery cables should not be
drawn taut; leave some slack for cable movement. Ensure all connections are routed properly and do not interfere
with the vehicular components, as this could damage cable or cause electrical short. Long battery cable runs may
have significant voltage drops that may cause the winch motor to not operate.
DO NOT CONNECT POWER CABLES TO BATTERY
UNTIL FINAL STEP OF INSTALLATION
Fig. 2-12
Black cable & wire (-)
Fig. 2-14
PAGE 7

WIRING INSTRUCTIONS

Red power cable (+)
2121 Blount Road Pompano Beach, FL 33069
Fig. 2-13
MileMarker.com 1.800.886.8647