Display Screen - Extron electronics TLP Pro 1230WTG User Manual

Display Screen

Display button in the navigation panel at the top of the screen to open the Display
Press the
screen.
Status
2
3
4
Minutes
Figure 10.
Display screen allows you to set the Sleep Timer , Auto Brightness ,
The
LCD Brightness , and Wake on Motion .
•
Sleep Timer — Toggle between
If the
•
power (
inactivity should be. The value can be between 1 and 120 minutes.
If the
•
•
Auto Brightness — Toggle between
Auto Brightness is on, the light sensor (see
• If
the amount of ambient light detected and automatically provides a suitable amount of
screen backlighting for the situation.
Auto Brightness is off, the screen brightness is not affected by changes in the
If
•
ambient light.
• LCD Brightness — Use the slider control to adjust the screen brightness between
100 .
• Wake on Motion — Toggle between
Sleep Mode (see "Configuring the Motion Sensor", below).
in
Configuring the Motion Sensor
The Motion Sensor
and at least 15° from the center axis.
Sleep Timer has been set and no motion has been detected for a user-defined
•
If the
period of time, the touchpanel enters sleep mode.
Sleep Timer has not been set, the touchpanel does not enter sleep mode.
• If the
Wake on Motion has been set and motion is detected by the sensor while the screen is in
•
If
sleep mode, the screen display is restored and active.
Wake on Motion has not been set and the screen is in sleep mode, touch the screen to
•
If
restore it to an active state.
Network Display Audio
Sleep Timer
0
On Off
Display Screen
On and Off (see "Configuring the Motion Sensor", below).
Sleep Timer is on, after a period of inactivity, the screen goes dark to save
Sleep Mode ). Use the up and down arrows to set how long the period of
Sleep Timer is off, the panel does not enter sleep mode.
B
(figure 2, ) detects motion between three to five feet from the touchpanel,
Input Advanced Exit
Auto Brightness
On Off
LCD Brightness
50 100
Wake on Motion
On Off
On and Off .
A
figure 2,
On and Off . For this to work, the touchpanel must be
TLP Pro 1230WTG • Setup Menu
on page 6) monitors
0 and
13