Front Panel - Fujitsu BS2000 SE Series Operating Manual

Additive Components

4.2.1 Front panel

The power button, operator control panel (OCP), magazines and LEDs are located on the front of the tape library.
The operator panel consists of an LCD screen, 4 push button switches and a power on/off button.
Figure 29: ETERNUS LT40 S2 front panel
No. Meaning
1 Left-hand or right-hand magazine. Left-hand magazine with mailslots.
2 Air vents
3 Power button. Pressing the button will power up or power down the library, see
device" .
4 READY LED (green).
Illuminated when power is on.
Blinking when there is tape or robotics activity.
5 CLEAN LED (yellow).
Illuminated when the tape drive has determined that a cleaning cartridge should be used.
6 the OCP's LCD screen, consisting of 128 x 64 characters.
Displays actions and status information, menu items or error messages.
7 ATTENTION LED (yellow).
Illuminated if the library has detected a condition that requires attention by Customer Support.
Please notify customer support.
8 ERROR LED (yellow).
Illuminated if an unrecoverable tape drive or library error occurs. A corresponding error message displays
on the LCD screen.
Please notify customer support.
9 Control key buttons (UP) and (DOWN).
These buttons are used to navigate through the OCP menu items.
10 Control key buttons CANCEL and ENTER.
The cancel button is used to cancel a user action and return to the last OCP menu item.
The enter button is used to go to a sub menu or execute an action.
"Operating panel on the
55