Device Settings - Fujitsu BS2000 SE Series Operating Manual

Additive Components

4.2.6.2 Device settings

The device settings are defined by Customer Support. The sections below provide information on how you can
change these settings.
If you wish to make any changes to the configuration, you should consult Customer Support, who will ensure that
the functionality of the device is retained in BS2000 operation.
Configuring the LAN connection
You configure the LAN connection of the tape library using the OCP:
> Select the OCP menu
> Configure the following parameters in the order specified:
1. DHCP - No DHCP (a static IP address is recommended)
2. (Static) IP address
3. Network mask
4. Gateway address
After you have completed network configuration, you should reboot the tape library (by switching the device off and
on). The RMU can then be accessed via the configured IP address.
Settings for operation with BS2000
You must specify the following settings for operation with BS2000:
> Select Configuration > Library
Configuration > Network .
in the OCP menu or Configuration > System via the RMU.
74