Fujitsu BS2000 SE Series Operating Manual page 78

Additive Components
Cannot load
Make sure you are using a recommended cleaning cartridge, see
the cleaning
Contact Customer Support.
cartridge
Errors displayed on operator control panel
"!" in OCP See
inventory
display
There is an Contact Customer Support
error code on (see
the LCD
screen
Bad performance
Try a new cartridge. A marginal cartridge can cause performance problems due to bad spots
on the tape requiring retries.
Backing up data that compresses poorly or is already compressed will lower performance.
Check the size of the files. Small file size can impact performance.Clean the tape drive.
Media attention LED issues
Contamination Avoid contamination of the library. Cartridges should be stored vertically in their plastic cases.
by loose Cleaning the tape drive when requested by the library.
debris.
Non- A cartridge should be acclimated for at least 24 hours before being used, particularly if it has
acclimated been stored at a substantially different temperature or level of humidity than the tape library.
media
Cartridge is Make sure you are using recommended data and cleaning cartridges, see
incompatible .
Expired A recommended cleaning cartridge is good for 50 library cleans.
cleaning
cartridge
Defective / If the Media Attention LED is cleared and - although the drive has been cleaned - immediately
contaminated re-displays each time a particular cartridge is reloaded that cartridge should be suspected as
media being defective.
Export the cartridge and load a known good cartridge. In some cases, a cartridge can be
worn out or be defective.
Any cartridge that is suspected of being defective or contaminated should NOT be reused in
any drive.
Table 6: Error handling ETERNUS LT40 S2
"Media" .
section "Tape library error codes" ).
"LTO tape cartridges" .
"LTO tape cartridges"
78