Eternus Jx40 (S2) Disk Storage System - Fujitsu BS2000 SE Series Operating Manual

Additive Components

4.1 ETERNUS JX40 (S2) disk storage system

This device is supported on SU300 only.
ETERNUS JX40 and ETERNUS JX40 S2 disk storage systems with an SAS port can be integrated into the SE
server when required:
Up to two systems can be connected to an SU300.
On an AU, up to two systems can be connected to one controller.
An ETERNUS JX40 (S2) disk storage subsystem occupies two height units in the rack.Per disk storage system, up
to 24 drives with the following gross capacity can be employed:
Up to 1200 GB per drive with ETERNUS JX40
Up to 1800 GB per drive with ETERNUS JX40 S2
Therefore, the ETERNUS JX40 disk storage system enables up to 28.8 TB and the ETERNUS JX40 S2 up to 43.2
TB of disk storage space to be provided. When mirroring is used, the net capacity of the disks is lower.
For details, please refer to the description provided by FUJITSU under
> Go to Support -> IT Products and Systems -> Storage
product group ETERNUS ->
The disk storage system is switched on/off automatically when the SU300 or AU is switched on/off.
Figure 25: ETERNUS JX40 (S2) disk storage system
The numbering of the various hard disk drives is shown by the numbers (0..23) below them.
This section covers the following topics:
Indicator elements (front)
Operating and indicator elements (rear)
Problem Solutions and Tips
product family ETERNUS JX ->
http://www.fujitsu.com/uk
. In Browse for Product select product line
product ETERNUS JX40 S2
:
Storage ->
.
47