Start-Up; Before Start-Up; Configuration Options For Start-Up; Base Settings - Burkert 3360 Series Quick Start Manual

9

START-UP

WARNING!
Risk of injury due to improper operation.
Improper operation may result in injuries as well as damage to
the device and the surrounding area.
▶ The operating personnel must know and understand the
contents of the Operating Instructions.
▶ The safety instructions must be followed and the device
used only as intended.
▶ Only adequately trained personnel may start up the system/
device.
9.1

Before start-up

NOTE!
Consider for devices requiring disassembly for installation.
If the actuator is disassembled, function X.TUNE must be
carried out again before start-up. See chapter "Adjustment of
position controller – execute X.TUNE".
32
9.2

Configuration options for start-up

• Configuration with the Bürkert Communicator PC software
on PC or tablet
This type of configuration is possible for all device types and
device variants.
The PC software Bürkert Communicator can be down-
loaded free of charge from the Bürkert website.
It requires the USB-büS interface set available as an
accessory.
Communication is performed via the device's büS service
interface.
• Configuration on display of device (optional)
Only possible on devices with display module.
• Use two capacitive buttons in device to adjust position
control (function X.TUNE)
Only possible on devices without display module.
9.3

Base settings

A start-up wizard that provides step-by-step guidance
through the base settings is available for Bürkert Com-
municator and the display.
(Configuration area
Process controller
English
Type 3360, 3361
Start-up
or
Position controller
→
START-UP)
→