iSE Series Electrocardiograph User Manual
Item
Axis calculation
method
Tachycardia
(greater than)
Bradycardia (less
than)
P Wave Normal
Duration
Algorithm
Sensitivity
Serious Diseases
Hint
RV5+SV1
RV6/SV2
RR/PP
Maximum
Signal
Range
QTc Formulas
Pacemaker
Detection Rate
10.7 User Setting
You have to enter password before configuring the user setting.
Description
Choose from: Area Method or Amplitude Method.
Enter a heart rate. The default value is 100 bpm.
Enter a heart rate. The default value is 60 bpm.
Choose from: 110ms or 120ms.
When the P wave duration exceeds this setting, system will
prompt you P wave widens.
Choose from: Normal or Weak.
Choose from: On, Off.
When On, diagnosis with serious illnesses will be marked with
"
" in the ECG report.
►◄
If selected, this measuring parameter will be displayed in auto
measurements and ECG report. This is selected by default.
If selected, this measuring parameter will be displayed in auto
measurements and ECG report. This is not selected by default.
If selected, this measuring parameter will be displayed in auto
measurements and ECG report. This is not selected by default.
Choose from: ±5 mV, ±10 mV, ±20 mV.
Choose from: Bazzet, Fridericia, Framingham, Hodges, and
QRS.
Bazzet, Fridericia, Framingham, Hodges, and QRS are displayed
in the ECG report as QTcBz, QTcFd, QTcFm, QTcHd, and
QTcQRS respectively.
Choose from: Low, High.
System Setting