EDAN iSe Series User Manual page 59

iSE Series Electrocardiograph User Manual
Report
VCG (visible when activated. Settings are displayed according to the functions
activated.)
Record Time
Report Type
X/Y/Z Wave
Analysis
VCG Parameters
QRS Gain
SAECG Filter
VCG Analysis
HRV Report (visible when activated)
RR Waveform
RR Interval List
Pharma Study Record Info (visible when activated)
Auto Save
Record Time
Report Type
addition to an automatic ECG printout.
Choose from: 10s, 1 min, 3 min, 5 min.
Choose from: VCG Report, TVCG Report, SAECG Report.
Choose from: Off, On.
If On, print X, Y, and Z waves on the VCG report.
Choose from: Off, On.
If On, print the diagnosis on the VCG and SAECG report.
Choose from: Off, On.
If On, print the detailed measurements on the VCG report.
Choose from: 10, 20, 40, and 80 mm/mV.
Change the gain of QRS loop, the gain of P loop and T loop will be
synchronized.
Choose from: 25-250 Hz, 40-250 Hz.
Choose from: X, Y, Z.
Display the real-time heart of the lead you choose on the recording
screen.
Choose from: Off, On.
If On, print the compressed waveforms on the HRV report.
Choose from: Off, On.
If On, print the RR interval list on the HRV report.
Choose from: Off, On.
If On, the system stores the ECGs recorded for the pharmaceutical
study.
Choose from: 0-1-3-5-10-15 (Minute), 0-1-3-5-7-9 (Minute),
0-2-4-6-8-10 (Minute), Customize.
This setting is related to the setting of report type below.
Choose from: All-Lead ECG Report, Single-Lead ECG Report.
If All-Lead ECG Report is selected, the system will print out a 9-lead
or 12-lead ECG report at the set N minute.
If Single-Lead ECG Report is selected, the system will acquire 10s
single-lead waveforms at the set N minute and at the end of
recording put all the acquired waveforms to a rhythm printout.
- 51 -
System Setting