Logging In To The Electrocardiograph - EDAN iSe Series User Manual

iSE Series Electrocardiograph User Manual
been fully recharged but its continuous use is greatly reduced, replace the
battery.
1. If the electrocardiograph is turned off because of low battery capacity or unexpected
power failure, the settings configured or the ECGs being recorded may not be saved.
2. The electrocardiograph cannot print an ECG report when the battery has low
capacity.
3. The use of electrocardiograph accessories (such as barcode scanner) will deplete
battery power at a faster rate. The battery will require more frequent recharging if
these accessories are used with the electrocardiograph.
To power off the electrocardiograph:
When operating on AC power
Press and hold the On/Off button. Select Power off from the pop-up menu. The
message
off in a few seconds. Remove the plug from the outlet.
When operating on battery power
Press and hold the On/Off button. Select Power off from the pop-up menu. The
message
off in a few seconds.
NOTE:
When turning off the device, follow the above sequence strictly, otherwise there may be
something wrong on the screen.

2.6 Logging in to the Electrocardiograph

After iSE is powered on, you need to log in by password or fingerprint. You can also
disable them by unselect the User Login in User Setting.
System is shutting down...
System is shutting down...
Setting Up the Electrocardiograph
CAUTION
is displayed. The electrocardiograph will be
is displayed. The electrocardiograph will be
- 27 -