Table Of Contents - Optimum OPTimill MH 25 SV Operating Manual

Table of Contents

1.1

Rating plate...............................................................................................................................................6

1.2

Safety instructions (warning notes)...........................................................................................................7

1.2.1 Classification of hazards...........................................................................................................................7

1.2.2 Other pictograms ......................................................................................................................................7

1.3

Intended use .............................................................................................................................................8

1.4

Reasonably foreseeable misuse...............................................................................................................9

1.4.1 Avoiding misuse........................................................................................................................................9

1.5

Possible dangers caused by the milling machine ...................................................................................11

1.6

Qualification of personnel .......................................................................................................................11

1.6.1 Target group ...........................................................................................................................................11

1.6.2 Authorized personnel..............................................................................................................................12

1.6.3 Obligations of the operating company ....................................................................................................12

1.6.4 Obligations of the operator .....................................................................................................................12

1.6.5 Additional requirements regarding the qualification................................................................................13

1.7

Operator positions ..................................................................................................................................13

1.8

Safety measures during operation..........................................................................................................13

1.9

Safety devices ........................................................................................................................................13

1.9.1 Emergency stop mushroom button.........................................................................................................14

1.9.2 Lockable main switch..............................................................................................................................14

1.9.3 Stored charge .........................................................................................................................................14

1.9.4 Separation guard ....................................................................................................................................15

1.10

Safety check ...........................................................................................................................................15

1.11

Personal protective equipment ...............................................................................................................16

1.12

For your own safety during operation .....................................................................................................16

1.13

Switching-off and securing the milling machine......................................................................................16

1.14

Using lifting equipment ...........................................................................................................................16

1.15

Icons on the milling machine ..................................................................................................................17

1.16

Electrical system.....................................................................................................................................17

1.17

Inspection deadlines ...............................................................................................................................17

Technical data

2.1

Electrical connection...............................................................................................................................18

2.2

Milling capacity .......................................................................................................................................18

2.3

Spindle seat ............................................................................................................................................18

2.4

Drill-mill head ..........................................................................................................................................19

2.5

Cross table..............................................................................................................................................19

2.6

Dimensions .............................................................................................................................................19

2.7

Working area ..........................................................................................................................................19

2.8

Speeds....................................................................................................................................................19

2.9

Environmental conditions........................................................................................................................20

2.10

Operating material ..................................................................................................................................20

2.11

Emissions ...............................................................................................................................................20

Delivery, interdepartmental transport, assembly and commissioning

3.1

Notes on transport, installation, commissioning .....................................................................................21

3.1.1 General risks during internal transport....................................................................................................21

3.2

Scope of delivery ....................................................................................................................................22

3.3

Installation and assembly .......................................................................................................................22

3.3.1 Requirements regarding the installation site...........................................................................................22

3.3.2 Load suspension point............................................................................................................................22

3.3.3 Assembly ................................................................................................................................................22

3.4

Dimensions .............................................................................................................................................23

3.5

First commissioning ................................................................................................................................24

MH25SV

Translation of original instruction

Version 1.0.4 - 2020-12-15