Table of Contents
Advertisement
1.5
Possible dangers caused by the milling machine
The milling machine was built using the latest technological advances.
Nonetheless, there remains a residual risk because the milling machine operates at
high speeds,
with rotating parts and tools,
electrical voltage and currents.
We have used construction resources and safety techniques to minimize the health risk to per-
sonnel resulting from these hazards.
If the milling machine is used and maintained by personnel who are not duly qualified, there
may be a risk resulting from incorrect or unsuitable maintenance of the milling machine.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
be duly qualified,
and strictly follow these operating instructions.
Always disconnect the milling machine from the electrical power supply when performing clean-
ing or maintenance works.
WARNING!
The milling machine may only be used with functional safety devices.
If you detect a failure in the safety devices or if they are detached, disconnect the milling
machine immediately!
All additional devices installed by the operator must be equipped with the prescribed
safety devices.
As the operating company, this is your responsibility!
Safety devices on page 13
1.6
Qualification of personnel
1.6.1
Target group
This manual is addressed to
the operating companies,
the operators,
the maintenance personnel.
Therefore, the warning notes refer to both the operation and maintenance of the milling
machine.
WARNING!
Disconnect the milling machine always from the electrical power supply. This will prevent it from
being used by unauthorized persons. The qualifications of the personnel for the different tasks
are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks performed beyond operation in standard mode
may only be performed by an operator if they are described in these instructions and if the oper-
ator has been specifically trained to perform them by the operating company.
Electrical specialist
Due to their professional training, knowledge and experience as well as knowledge of respec-
tive standards and regulations, qualified electricians are able to perform work on the electrical
Version 1.0.4 - 2020-12-15
Translation of original operating manual
MH25SV
EN
11
Advertisement
Table of Contents
