Table of Contents
Advertisement
The automatic function enables a window to fully
open or close without holding the switch down or
up.
To fully open the window, push the power window
switch down to the second detent and release the
switch. To fully close the window, pull the power
window switch up to the second detent and release
the switch. The switch does not have to be held
during window operation.
To stop the window open/close operation during
the automatic function, push down or pull up the
switch in opposite directions.
If the window does not close
automatically
If the power window automatic function (closing
only) does not operate properly, perform the follow-
ing procedure to initialise the power window sys-
tem.
1. With the engine running.
2. Close the door.
3. Open the window completely by operating the
power window switch.
4. Pull the power window switch and hold it to close
the window, and then hold the switch more than
3 seconds after the window is closed completely.
5. Release the power window switch. Operate the
window by the automatic function to confirm the
initialisation is complete.
If the power window automatic function does not
operate properly after performing the procedure
above, have your vehicle checked by an approved
dealer or qualified workshop.
86
Instruments and controls
POWER OUTLETS
The power outlet is used to power electrical acces-
sories.
Instrument panel (upper)
Instrument panel (lower)
Console box (where fitted)
JVI1023XZ
Use the cutout
A between the lid and the console
j
box to route a connected power cable with the con-
sole box lid closed.
Do not place any objects on the instrument panel.
Such objects may become dangerous projectiles
and cause injury if a supplemental air bag inflates
(where fitted).
CAUTION
•
NIC3668
Do not leave a power cable on the instrument
panel in direct sunlight. The surface of the in-
strument panel may become very hot result-
ing in damage to the power cable.
•
Do not put a liquid container near the power
outlet. Spilled contents may get into the power
outlet and can result in a malfunction.
•
The outlet and plug may be hot during or im-
mediately after use.
JVI1025XZ
WARNING
Advertisement
Table of Contents
