Table of Contents
Advertisement
The speed limiter operation switches are located
on the steering wheel (right hand side).
The speed limiter operating condition is shown on
the top of vehicle information display. For details,
see "Vehicle information display" in the "2. Instru-
ments and controls" section.
SPEED LIMITER OPERATIONS
➀
<CANCEL> switch
A
<RES/+> (Resume) switch
j
B
<SET/–> (Set) switch
j
➁
Speed limiter main "ON/OFF" switch
➂
Cruise control main "ON/OFF" switch. (For
details, see "Cruise control (where fitted)"
earlier in this section)
➃
Speed limiter symbol
➄
Set speed value
Turning the speed limiter on
The speed limiter can be switched on after engine
start or when driving.
NAA1866
Push the speed limiter main "ON/OFF" switch
Setting speed limit
Push the <SET/–> switch
Depending on the model:
•
The speed limit will be set at the current speed.
When driving less than 30 km/h (20 MPH), the
speed limiter will be set to the minimum pos-
sible set speed of 30 km/h (20 MPH).
•
Set the speed limiter while driving over 30 km/h
(20 MPH).
When the speed limit is set, the speed limiter sym-
➃
bol
and the set speed value
the vehicle information display. The limiter symbol
will turn green.
Changing a speed limit
Use either of the following operations to change an
active speed limit:
•
•
NAA1666
The new set speed limit value
the vehicle information display.
When the actual vehicle speed exceeds the set
speed, an audible warning will be heard a short time
after the set speed is exceeded and driver interven-
tion is not detected.
➂
.
Cancelling a speed limit
To cancel a set speed limit, push the <CANCEL>
B (downwards).
j
switch
speed value
will be turned off.
It is also possible to override the speed limiter by
fully depressing the accelerator pedal beyond the
resistance point.
•
➄
will illuminate in
Push and release the <RES/+> (Resume) switch
A upwards or <SET/–> switch
B downwards.
j
j
Each time you do this, the set speed will increase
or decrease by 1 km/h (1 MPH).
Push and hold the <RES/+> (Resume) switch
A upwards or <SET/–> switch
B downwards.
j
j
The set speed will increase or decrease to the
next multiple of 5 km/h (5 MPH) and then in steps
of 5 km/h (5 MPH).
➄
will be displayed in
➀
. The speed limiter symbol
➄
in the vehicle information display
WARNING
The vehicle may accelerate when the speed
limiter cancels.
Starting and driving
➃
and the set
227
Advertisement
Table of Contents
