Table of Contents
Advertisement
1. If the booster battery is in another vehicle
sition the two vehicles
A and
B to bring the bat-
j
j
teries into close proximity to each other.
CAUTION
•
Do not allow the two vehicles to touch.
•
If the battery of vehicle
B equipped with
j
the
Remote
Control
Key
248
In case of emergency
M9T 2.3DCI engine models
A , po-
discharged, the steering wheel will lock
j
and cannot be turned with the ignition
switch in the OFF position. Supply power
using jumper cables before pushing the ig-
nition switch to any position other than the
OFF position and disengaging the steering
lock.
system
is
2. Apply the parking brake.
3. Automatic transmission (AT) model:
Move the shift lever to the P (Park) position.
Manual transmission (MT) model:
Move the shift lever to the N (Neutral) position.
4. Switch off all unnecessary electrical systems
(headlights, heater, air conditioner, etc.).
5. Place the ignition switch in the OFF position.
6. Remove the vent caps, where fitted, on the bat-
tery.
7. Cover the battery with a firmly wrung out moist
cloth to reduce the hazard of an explosion.
8. Connect the jumper cables in the sequence as
➀
➁
➂
illustrated (
,
,
CAUTION
•
Always connect positive
and negative
- to body ground, NOT to the
j
battery's negative
•
Be sure that the jumper cables do not touch
moving parts in the engine compartment.
•
NCE477
Be sure that the jumper cable's clamps do
not contact any other metal.
9. Start the engine of the booster vehicle
it run for a few minutes.
10. Depress the accelerator pedal of the booster ve-
hicle
A to race the engine at about 2,000 rpm.
j
11. Start the engine of the jumped vehicle
normal manner.
➃
,
).
+ to positive
+
j
j
- .
j
A and let
j
B in the
j
Advertisement
Table of Contents
