Table of Contents
Advertisement
Additional fuse box
1. Be sure the ignition switch is in the OFF position.
2. Be sure the headlight switch is in the OFF posi-
tion.
3. Remove the fuse box cover
A from beneath the
j
glove box.
4. Locate the fuse that needs to be replaced.
5. Remove the fuse using the fuse puller located in
the main fuse box.
6. If the fuse is open, replace it with a new fuse.
7. Install the fuse box cover.
If the new fuse also opens, after installing, have the
electrical system checked, and if necessary repaired,
by an approved dealer or qualified workshop.
Extended storage fuse switch
(where fitted)
NTI386
To reduce battery drain, the extended storage fuse
switch comes from the factory switched off. Prior to
delivery of your vehicle, the switch is pushed in
(switched on) and should always remain on.
If the extended storage fuse switch is not pushed in
(switched on), the [Shipping Mode On Push Storage
Fuse] warning may appear in the vehicle informa-
tion display. See "Indicators for operation" in the
"2. Instruments and controls" section.
If any electrical equipment does not operate, re-
move the extended storage fuse switch and check
for an open fuse.
NOTE
If the extended storage fuse switch malfunctions
or if the fuse is open, it is not necessary to replace
the switch. In this case, remove the extended stor-
age fuse switch and replace it with a new fuse of
the same rating.
How to remove the extended storage fuse
switch:
1. To remove the extended storage fuse switch, be
sure the ignition switch is in the OFF or LOCK po-
sition.
2. Be sure the headlight switch is in the OFF posi-
tion.
3. Remove the fuse box cover.
4. Pinch the locking tabs
the storage fuse switch.
5. Pull the extended storage fuse switch straight
out from the fuse box
JVM0462XZ
Maintenance and do-it-yourself
➀
found on each side of
➁
.
279
Advertisement
Table of Contents
