Table of Contents
Advertisement
CAUTION
Do not put the speed restriction label on the
steering wheel pad, the speedometer or the
warning light locations.
➀
2. Take the hose
and the power plug
the air compressor. Remove the cap of the bottle
holder from the air compressor.
3. Remove the cap of the tyre sealant bottle.
NOTE
Leave the bottle seal intact. Screwing the
bottle onto the bottle holder will pierce the
seal of the bottle.
4. Screw the bottle clockwise onto the bottle holder
of the air compressor.
5. Remove the cap of the tyre valve on the flat tyre.
6. Remove the protective cap of the hose and screw
the air tube
A of the compressor securely onto
j
the tyre valve. Make sure that the air compressor
switch is in the "OFF" (0) position and the pres-
sure release valve
sert its power plug into the power outlet in the
vehicle.
SCE0868
➁
out of
SCE0870Z
B is securely closed, then in-
j
NOTE
Use the power socket located on the lower
➀
part of the cockpit
.
7. Check the specified tyre pressure on the tyre plac-
ard that is affixed to the driver's side centre pillar.
8. Place the ignition switch in the ACC position.
Then turn the compressor switch to the ON (−)
position and inflate the tyre up to the pressure
that is specified on the tyre placard affixed to the
driver's side centre pillar if possible, or to the
minimum of 180 kPa (1.8 bar, 26 psi), for tyre
205R16 250 kPa (2.5 bar, 36 psi). Turn the air com-
pressor off briefly in order to check the tyre pres-
sure with the pressure gauge.
If the tyre is inflated to higher than the specified
pressure, adjust the tyre pressure by releasing air
with the pressure release valve. The cold tyre
pressures are shown on the tyre placard affixed
to the driver's side centre pillar.
In case of emergency
NIC3668
245
Advertisement
Table of Contents
