Table of Contents
Advertisement
SECURITY SYSTEM (where fitted)
Your vehicle has either or both of the following se-
curity systems:
•
Theft warning system
•
Anti-Theft System (ATS*)
*: Immobilizer
The security condition will be shown by the security
indicator light.
THEFT WARNING SYSTEM
(where fitted)
The theft warning system provides visual and audio
alarm signals if parts of the vehicle are disturbed.
Security indicator light
The security indicator light, located on the meter
panel, operates whenever the ignition switch is in
the LOCK, OFF or ACC position. This is normal.
110
Pre-driving checks and adjustments
How to activate system (where fitted)
1. Close all windows.
The system can be armed even if the windows
are open.
2. Place the ignition switch in the OFF position.
3. Carry the integrated key fob or the Remote Con-
trol Key with you and get out of the vehicle.
4. Close and lock all doors. The doors can be locked
with the integrated key fob, the Remote Control
Key, door handle request switch (where fitted),
power door lock switch or mechanical key.
5. Confirm that the security indicator light comes
on. The security indicator light glows for about
30 seconds and then blinks. The system is now
activated. If, during this 30 second time period,
the door is unlocked or the ignition switch is
placed in the ACC or ON position, the system will
not activate.
Even when the driver and/or passengers are in
the vehicle, the system will activate with all doors
locked with the ignition switch in the LOCK posi-
tion. When pushing the ignition switch to the ACC
or ON position, the system will be released.
SIC2045Z
Theft warning system operation
The vehicle security system will give the following
alarm:
•
The hazard indicator blinks and the horn sounds
intermittently.
•
The alarm automatically turns off after approxi-
mately 30 seconds. However, the alarm reacti-
vates if the vehicle is tampered with again.
The alarm is activated by:
•
Unlocking the door without using the integrated
key fob, the Remote Control Key, the door handle
request switch (where fitted) or the mechanical
key. (Even if the door is opened by releasing the
door inside lock knob, the alarm will activate.)
How to stop alarm
•
The alarm will stop only by unlocking a door by
pushing the UNLOCK button on the Remote
Control Key.
•
The alarm will not stop if the ignition switch is
placed in the ACC or ON position.
ANTI-THEFT SYSTEM (ATS)
The Anti-Theft System (ATS) will not allow the en-
gine to start without the use of the registered ATS
key.
If the engine does not start using the registered ATS
key, it may be due to interference caused by:
•
Another ATS key.
•
Automated toll road device.
•
Automated payment device.
•
Other devices that transmit similar signals.
Start the engine using the following procedure:
1. Remove any items that may be causing the inter-
ference away from the ATS key.
2. Leave the ignition switch in the ON position for
approximately 5 seconds.
3. Place the ignition switch in the OFF or LOCK po-
sition, and wait approximately 10 seconds.
4. Repeat steps 2 and 3 again.
Advertisement
Table of Contents
