Renault ALASKAN 2020 Vehicle User Manual page 161

AUDIO MAIN OPERATION
The audio unit operates when the ignition switch is
in ACC or ON position.
m Power ON/OFF button
Press the button to switch on the audio unit. If
the audio unit was switched off using the ignition
switch, it can also be switched on with the ignition
switch. The source that was playing immediately
before the unit was switched off will resume playing
and the volume will be set to the previous volume
level.
The audio unit can be switched off by pressing
or by turning the ignition switch to the "OFF" or
LOCK position.
Volume (VOL) level control
Turn the <VOL> dial clockwise or anticlockwise to
adjust the volume level.
The audio unit is equipped with a speed control vol-
ume function, this means that the audio system au-
tomatically adjusts the volume level in relation to
vehicle speed. For details, see "[Speed Volume]
menu" later in this section.
RADIO OPERATION
When the (power ON/OFF) button is pressed,
the audio unit will switch on with the last received
radio station, if the audio unit was previously
switched off in radio mode.
The radio is able to receive multiple kinds of audio
transmissions:
– FM
– AM
Radio band select buttons
Press the <RADIO> button to change the audio
transmission source as follows:
FM1 FM2 AM FM1
When <RADIO> button is pressed, the radio will
come on at the last received radio station. If audio is
already playing using one of the other input sources
(iPod, Bluetooth, CD, USB, AUX-in) pressing the
,
<RADIO> button will switch off the playing source
mode and the last received radio station will be se-
lected.
Setting preset stations
Auto populating the [FM List]:
When the <RADIO> button is pressed for more than
1.5 seconds the six stations with the strongest sig-
nals are stored in the preset (1 to 6) buttons of the
band. During the search, a notification message
[Updating FM List] appears in the display and the
sound is muted until the operation is complete.
Once completed, the radio reverts to the previously
selected radio station.
Manual tuning
When adjusting the broadcasting station frequency
manually access the [FM List] and turn the <MENU>
dial until the desired station is tuned in.
The frequency increases or decreases in steps of
100 kHz on the FM band, and 9 kHz on the AM band.
Display screen, heater and air conditioner, and audio system
WARNING
The radio should not be tuned while driving in or-
der for full attention to be given to the driving
operation.
SEEK tuning buttons
FM mode:
Pressing the or button starts the tuning
mode. A short press of the button will increase or
decrease the frequency a single step. Pressing the
button longer will activate the seek mode. The radio
tuner seeks from low to high or high to low fre-
quencies and stops at the next broadcasting sta-
tion. During seek mode, the audio output is muted.
If no broadcasting station can be found within the
complete band cycle, it will return to the initial fre-
quency.
➀ ➁➂➃➄➅
Preset station buttons
Pressing a preset button for less than 2 seconds will
select the stored radio station.
Pressing a preset button for more than 2 seconds
while in the [FM list] or radio main screen will cause
the station currently being received to be stored
against that preset button.
•
Twelve stations (if available) can be stored in the
FM bands. (Six each for FM1 and FM2)
•
Six stations (if available) can be set for the AM
band.
If the battery is disconnected, or if the fuse blows,
the radio memory will be erased. In that case, reset
the desired stations after battery connection or
fuse replacement.
153