Interior Parts Cleaning & Sanitizing; Coffee & Soluble Canisters - Cafection Encore Ground Service & Installation Manual

SERVICE & INSTALLATION MANUAL for Cafection's Encore Ground
www.cafection.com
7.8 Interior Parts Cleaning & Sanitizing
For food safety reasons, do not use soap or detergent to clean the inside of the brewer. Use hot
water or chemical products recommended by the manufacturer. Wiping with towels or cloths can
recontaminate sanitized food-contact surfaces. Therefore, it is recommended to air dry completely
all sanitized food-contact surfaces before reinstalling them in the machine.
Brush away coffee grounds and particles inside the brewer using the brush for coffee grounds and
a small dust pan, then clean the inside with hot water.
Interior parts to be cleaned:
- Coffee & soluble canisters.
- Soluble whipper assembly.
- Brew group assembly.
- Fan.
7.8.1 Coffee & Soluble Canisters
Soluble Whipper Assembly
Frequency: weekly or every 200 cycles
If there is product accumulation, remove the soluble
whipper assembly for manual cleaning under hot water.
1. Remove the tube from the base.
2. Lift the funnel. Remove the whipper chamber and the disk, then twist off the whipper
3. Clean all parts and gaskets with hot water. Use the small brush for tubes, if necessary.
4. Air dry completely.
5. Reinstall all parts in reverse order.
6. Order a large beverage of each product to ensure that all parts and switches are
Exit option 1
Exit option 2
ENCORE GROUND Rev. 0 2017-04
800-561-6162
base.
working properly.
Coffee & Soluble Canisters
Frequency: monthly or every 1,000 cycles
It is recommended to remove, empty and clean the coffee and soluble canisters
every month to avoid coffee grounds and powder to accumulate on the walls of
the canisters and alterate the beverages quality.
1. To remove soluble canisters, open the brewer's door (exit option 2).
To remove coffee canisters, remove the plastic top lid (exit option 1).
2. Pull the soluble canisters out of the brewer to disengage them from the
motor and transmission. Tilt the canisters carefully to disengage them from
the top walls while avoiding powder fall.
Pull the coffee canisters outwards to disengage them from the motor and
transmission. Pull the canisters out of the machine through the top.
3. Clean and sanitize under hot water and air dry completely.
4. Reinstall all parts and reload products in the canisters.
5. Order a large beverage of each soluble and coffee to confirm that all parts
and switches are working properly.
61